Brake Master Cylinder (W/ Vsc) -- Removal |
| 1. PRECAUTION |
| 2. REMOVE COOL AIR INTAKE DUCT SEAL |
 |
Remove the 7 clips and duct seal.
| 3. REMOVE ENGINE ROOM SIDE COVER LH |
Remove the 3 clips and side cover.
 |
| 4. REMOVE ENGINE ROOM SIDE COVER RH |
Remove the nut, 2 clips and side cover.
 |
| 5. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH |
 |
Using a clip remover, detach the 3 clips and remove the side seal.
| 6. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.
| 7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH |
Remove the nut, wiper arm and blade.
| 8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH |
Remove the nut, wiper arm and blade.
| 9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH |
 |
Pull the cowl side seal in the direction indicated by the arrow in the illustration to detach the 2 claws and remove the cowl side seal.
| 10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH |
- HINT:
- Use the same procedures described for the LH side.
| 11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
Remove the 2 clips and detach the 5 claws.
 |
Pull the ventilator louver in the direction indicated by the arrow in the illustration to detach the 10 claws and remove the ventilator louver.
 |
| 12. DRAIN BRAKE FLUID |
- NOTICE:
- If brake fluid leaks onto any painted surface, clean it off completely.
| 13. REMOVE FRONT WHEEL |
| 14. REMOVE ENGINE ROOM RELAY NO.3 BLOCK |
Remove the bolt, nut and relay No.3 block.
- NOTICE:
- Cover the relay No.3 block with a shop rag or piece of cloth to prevent brake fluid from adhering to it.
 |
| 15. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
Disengage the clamp and disconnect the warning switch connector.
Using SST, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.
- SST
- 09023-00101
 |
Remove the 2 nuts and brake master cylinder sub-assembly from the brake booster assembly.
 |
Remove the O-ring from the brake master cylinder sub-assembly.