Dtc 01-Dd Master Reset (G/W)
DESCRIPTION
INSPECTION PROCEDURE
CHECK POWER SOURCE CIRCUIT (RADIO RECEIVER ASSEMBLY)
CHECK AVC-LAN CIRCUIT (GATEWAY ECU - RADIO RECEIVER ASSEMBLY)
CHECK RADIO RECEIVER ASSEMBLY
DTC 01-DD Master Reset (G/W) |
DTC 01-DF Master Error (G/W) |
DESCRIPTION
DTC No.
| DTC Detection Condition
| Trouble Area
|
01-DD *1
| When device that should be master has been disconnected after engine starts
| - Wire harness
- Gateway ECU
- Radio receiver assembly
|
01-DF *2
| When device with display fails and master is switched to audio device. Also when communication error between sub master (audio) and master occurs, this code is stored
|
- HINT:
- *1: This code may be stored if the engine switch is started, turned off, and then started again.
- *2: This code may be stored if the engine is started, idled for 60 seconds, turned off, and then started again.
INSPECTION PROCEDURE
1.CHECK POWER SOURCE CIRCUIT (RADIO RECEIVER ASSEMBLY) |
Please follow this page (Click here).If the power source circuit is operating normally, proceed to the next step.
2.CHECK AVC-LAN CIRCUIT (GATEWAY ECU - RADIO RECEIVER ASSEMBLY) |
Please follow this page (Click here).If the AVC-LAN circuit is operating normally, proceed to the next step.
3.CHECK RADIO RECEIVER ASSEMBLY |
Check that the malfunction disappears when the radio receiver assembly is replaced with a normal one.
- OK:
- Malfunction disappears.
| REPLACE RADIO RECEIVER ASSEMBLY |
|
|
NG |
|
|
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|