Crankshaft Position Sensor Removal
Engine. Lexus Gs430, Gs300. Uzs190 Grs190
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE COOL AIR INTAKE DUCT SEAL
REMOVE ENGINE ROOM SIDE COVER RH
REMOVE ENGINE ROOM SIDE COVER LH
REMOVE NO. 1 AIR CLEANER INLET
REMOVE V-BANK COVER
REMOVE V-RIBBED BELT
REMOVE ENGINE UNDER COVER
DISCONNECT COMPRESSOR ASSEMBLY
REMOVE CRANKSHAFT POSITION SENSOR
Crankshaft Position Sensor -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE COOL AIR INTAKE DUCT SEAL |
Remove the 7 clips and duct seal.
| 3. REMOVE ENGINE ROOM SIDE COVER RH |
Loosen the nut and remove the 2 clips and side cover.
| 4. REMOVE ENGINE ROOM SIDE COVER LH |
Remove the 3 clips and side cover.
| 5. REMOVE NO. 1 AIR CLEANER INLET |
Remove the bolt and air cleaner inlet.
Remove the 2 nuts and V-bank cover.
While releasing the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.
While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the belt tensioner.
| 8. REMOVE ENGINE UNDER COVER |
Using a clip remover, remove the 3 clips.
Remove the 10 screws and under cover.
| 9. DISCONNECT COMPRESSOR ASSEMBLY |
Disconnect the magnetic clutch connector.
Remove the 3 bolts and nut.
Using an E8 "torx" socket, remove the stud bolt and compressor.
| 10. REMOVE CRANKSHAFT POSITION SENSOR |
Disconnect the sensor connector.
Remove the bolt and sensor.
