Air Conditioning Amplifier Removal
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT DOOR SCUFF PLATE RH
REMOVE FRONT DOOR OPENING TRIM COVER RH
REMOVE INSTRUMENT SIDE PANEL RH
REMOVE FRONT CONSOLE UPPER PANEL GARNISH
REMOVE CONSOLE UPPER PANEL ASSEMBLY
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY
REMOVE NO. 2 AIR DUCT
REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
Air Conditioning Amplifier -- Removal |
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT DOOR SCUFF PLATE RH |
- HINT:
- Use the same procedures described for the LH side.
3. REMOVE FRONT DOOR OPENING TRIM COVER RH |
- HINT:
- Use the same procedures described for the LH side.
4. REMOVE INSTRUMENT SIDE PANEL RH |
Using a screwdriver, detach the 2 claws and 4 clips, and remove the side panel.
- HINT:
- Tape the screwdriver tip before use.
5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
Using a clip remover, detach the claws and remove the garnish.
- HINT:
- Tape the clip remover tip before use.
6. REMOVE CONSOLE UPPER PANEL ASSEMBLY |
Twist the shift lever knob in the direction indicated by the arrow and remove it.
Using a screwdriver, detach the 9 clips.
- HINT:
- Tape the screwdriver tip before use.
Remove the ash receptacle and then disconnect the connector.
7. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
Remove the screw.
Using a screwdriver, detach the 3 clips and 3 claws.
- HINT:
- Tape the screwdriver tip before use.
Remove the finish panel end.
8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Using a screwdriver, detach the 4 clips.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the connector and clamp, and remove the under cover.
9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY |
Remove the 3 bolts and front passenger side knee airbag assembly.
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
10. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY |
Remove the 4 screws.
Detach the 2 clips and claw.
Disconnect the connector and clamp.
Remove the glove compartment door.
11. REMOVE NO. 2 AIR DUCT |
Remove the screw and air duct.
12. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY |
Disconnect the connector.
Remove the screw and A/C amplifier.