Cruise Control System. Lexus Gs430, Gs300. Uzs190 Grs190
Cruise Control. Lexus Gs430, Gs300. Uzs190 Grs190
Cruise Control Main Switch -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 2 STEERING WHEEL COVER LOWER |
Using a screwdriver, remove the steering wheel No.2 cover lower.
- HINT:
- Tape up the screwdriver tip before use.
 |
| 3. REMOVE NO. 3 STEERING WHEEL COVER LOWER |
Using a screwdriver, remove the steering wheel No.3 cover lower.
- HINT:
- Tape up the screwdriver tip before use.
 |
| 4. REMOVE STEERING WHEEL PAD |
Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
 |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
 |
Disconnect the horn connector.
Disconnect the 2 connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 5. REMOVE STEERING WHEEL ASSEMBLY |
For 3GR-FSE (Click here)
For 3UZ-FE (Click here)
| 6. REMOVE CRUISE CONTROL MAIN SWITCH |
 |
Disconnect the connector.
Remove the 2 screws and switch.