Drive Belt Installation

Install the V-ribbed belt.

While turning the belt tensioner counterclockwise, remove the bar.

NOTICE:

1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
   
2. Check that the V-ribbed belt is properly set to each pulley.
   

If it is difficult to install the V-ribbed belt, perform the following procedure.

1. Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.
   

2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
   

   NOTICE:

   1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      
   2. Check that the V-ribbed belt is properly set to each pulley.
      

Install the air cleaner inlet with the bolt.

Torque:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Install the intake duct seal with the 7 clips.