Floor Shift Assembly Installation

Install the floor shift assembly with the 4 bolts.

Torque:

8.3 N*m{85 kgf*cm, 73 in.*lbf}

Connect the connector to the floor shift assembly.

Install the floor shift gear shifting rod sub-assembly with the nut.

Torque:

13 N*m{130 kgf*cm, 9 ft.*lbf}

Remove the nut and disconnect the shifting rod.

Turn the control shaft lever of the neutral start switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.

NOTICE:

Do not push the shift lever too hard.

After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.

When shifting from the P to the R position with the engine switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

Install the heat insulator No.1 with the 4 nuts.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}

Install the console box duct with the 2 clips.

Connect the connector.

Install the console box with the 4 bolts and 2 screws.

Attach the 4 clips to install the register.

Connect the connector.

Attach the 4 clips to install the console box.

Attach the 4 clips and 3 claws to install the finish panel end.

Install the screw.

Attach the 3 clips and 3 claws to install the finish panel end.

Install the screw.

Connect the connector.

Attach the 9 clips to install the ash receptacle.

Install the shift lever knob and twist it in the direction indicated by the arrow.

Attach the claws to install the garnish.