Headlight Dimmer Switch Removal
Lighting. Lexus Gs430, Gs300. Uzs190 Grs190
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
REMOVE NO. 2 STEERING WHEEL COVER LOWER
REMOVE NO. 3 STEERING WHEEL COVER LOWER
REMOVE STEERING WHEEL PAD
REMOVE STEERING WHEEL ASSEMBLY
REMOVE STEERING COLUMN COVER
REMOVE SPIRAL CABLE SUB-ASSEMBLY W/ STEERING SENSOR
REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
Headlight Dimmer Switch -- Removal |
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
3. REMOVE NO. 2 STEERING WHEEL COVER LOWER |
Using a screwdriver, remove the steering wheel No.2 cover lower.
- HINT:
- Tape up the screwdriver tip before use.
4. REMOVE NO. 3 STEERING WHEEL COVER LOWER |
Using a screwdriver, remove the steering wheel No.3 cover lower.
- HINT:
- Tape up the screwdriver tip before use.
5. REMOVE STEERING WHEEL PAD |
Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
6. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and main shaft assembly.
Using SST, remove the steering wheel assembly.
- SST
- 09950-50013(09951-05010,09952-05010,09953-05020,09954-05011)
7. REMOVE STEERING COLUMN COVER |
Remove the 3 screws.
Disengage the 2 claws to remove the steering column cover lower.
- NOTICE:
- Do not damage the tilt and telescopic switch.
Disengage the 4 clips to separate the steering column cover upper.
Disengage the claw to remove the steering column cover upper.
8. REMOVE SPIRAL CABLE SUB-ASSEMBLY W/ STEERING SENSOR |
Disconnect the connectors from the spiral cable with steering sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Disengage the 3 claws and remove the spiral cable with steering sensor.
9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY |
Disconnect the connector.
Detach the claw and remove the wiper switch.
- NOTICE:
- If the claw is pushed with excessive force, it may break.
10. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY |
Disconnect the connector.
Detach the clamp from the dimmer switch as shown in the illustration.
Detach the claw and remove the dimmer switch as shown in the illustration.