Rear Seat Entertainment System Sound Signal Circuit Between Radio Receiver And Television Display Assembly
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
REAR SEAT ENTERTAINMENT SYSTEM - Sound Signal Circuit between Radio Receiver and Television Display Assembly |
DESCRIPTION
The television display assembly sends the sound signal to the radio and display receiver assembly through this circuit.The sound signal that has been sent sent to the speakers.If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY) |
Disconnect the H52 radio and display receiver assembly connector.
Disconnect the W14 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
H52-2 (CDR+) - W14-9 (R1+)
| Always
| Below 1 Ω
|
H52-3 (CDR-) - W14-10 (R1-)
| Always
| Below 1 Ω
|
H52-4 (CDL+) - W14-7 (L1+)
| Always
| Below 1 Ω
|
H52-5 (CDL-) - W14-8 (L1-)
| Always
| Below 1 Ω
|
W14-11 (SLD1) - Body ground
| Always
| 10 kΩ or higher
|
H52-2 (CDR+) - Body ground
| Always
| 10 kΩ or higher
|
H52-3 (CDR-) - Body ground
| Always
| 10 kΩ or higher
|
H52-4 (CDL+) - Body ground
| Always
| 10 kΩ or higher
|
H52-5 (CDL-) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
