REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (for LHD)
REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (for RHD)
Clearance Sonar Main Switch -- Removal |
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH |
 |
Put protective tape around the door scuff plate.
Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1 Protective Tape
| 2. REMOVE COWL SIDE TRIM BOARD LH |
 |
Remove the clip.
Detach the clip and claw and remove the cowl side trim board.
| 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
 |
for LHD:
Remove the screw.
Detach the 2 clips and 2 guides and remove the No. 1 instrument panel under cover.
Disconnect each connector.
for RHD:
Remove the screw.
Detach the 3 clips and 2 guides and remove the No. 1 instrument panel under cover.
Disconnect each connector.
 |
| 4. REMOVE INSTRUMENT SIDE PANEL LH |
 |
Put protective tape around the instrument side panel.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 5 clips, claw and 3 guides and remove the instrument side panel.
| 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD) |
 |
Put protective tape around the instrument cluster finish panel ornament.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.
| 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD) |
 |
Detach the 4 clips.
Disconnect each connector and remove the instrument panel finish panel.
| 7. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD) |
 |
Detach the 4 clips.
Disconnect each connector and remove the instrument panel finish plate garnish.
| 8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
 |
Using a screwdriver, detach the 2 claws and open the cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1 Protective Tape
w/o Knee Airbag:
Remove the 2 bolts <C>.
Detach the 7 clips.
Disconnect each connector and each cable and remove the lower instrument panel finish panel.
 |
w/ Knee Airbag:
Remove the 2 bolts <C>.
Detach the 14 clips.
Disconnect each connector and each cable and remove the lower instrument panel finish panel.
 |
| 9. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (for LHD) |
Detach the 2 claws and remove the back sonar or clearance sonar switch.
 |
| 10. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (for RHD) |
Detach the 2 claws and remove the back sonar or clearance sonar switch.
 |