Blind Spot Monitor System Reverse Signal Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH ASSEMBLY - BATTERY)
CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BACK-UP LIGHT SWITCH ASSEMBLY)
BLIND SPOT MONITOR SYSTEM - Reverse Signal Circuit |
DESCRIPTION
The blind spot monitor sensor RH receives a reverse signal from the back-up light switch assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1.INSPECT BACK-UP LIGHT SWITCH ASSEMBLY |
Remove the back-up light switch assembly (LandCruiser RM0000047AR005X.html).
Inspect the back-up light switch assembly (LandCruiser RM0000047AP005X.html).
| 2.CHECK HARNESS AND CONNECTOR (BACK-UP LIGHT SWITCH ASSEMBLY - BATTERY) |
Disconnect the back-up light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
C41-2 - Body ground
| Engine switch on (IG)
| 11 to 14 V
|
Engine switch off
| Below 1 V
|
Text in Illustration*a
| Front view of wire harness connector
(to Back-up Light Switch Assembly)
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BACK-UP LIGHT SWITCH ASSEMBLY) |
Disconnect the R43 blind spot monitor sensor RH connector.
Disconnect the C41 back-up light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
R43-8 (SPR) - C41-1
| Always
| Below 1 Ω
|
R43-8 (SPR) - Body ground
| Always
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
