Seat Belt Control Ecu -- Installation |
| 1. INSTALL SEAT BELT CONTROL ECU |
Install the seat belt control ECU with the bolt.
Text in Illustration *A for LHD *B for RHD - Torque:
- 7.0 N*m{71 kgf*cm, 62 in.*lbf}
 |
Connect the 2 connectors.
| 2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Connect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
 |
Install the airbag assembly with the 4 bolts.
- Torque:
- 10 N*m{102 kgf*cm, 7 ft.*lbf}
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Connect each connector and each cable.
w/o Knee Airbag:
Attach the 7 clips to install the lower instrument panel finish panel.
w/ Knee Airbag:
Attach the 14 clips to install the lower instrument panel finish panel.
Install the 2 bolts <C>.
Attach the 2 claws to close the cover.
| 4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
for LHD:
Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.
Install the screw.
for RHD:
Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.
Install the screw.
| 5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY |
Connect each connector.
Attach the 4 clips to install the instrument panel finish panel.
| 6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD) |
Attach the 3 clips to install the instrument cluster finish panel ornament.
| 7. INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD) |
Connect each connector.
Attach the 4 clips to install the instrument panel finish plate garnish.
| 8. INSTALL INSTRUMENT SIDE PANEL LH (for LHD) |
Attach the 5 clips, claw and 3 guides to install the instrument side panel.
| 9. INSTALL INSTRUMENT SIDE PANEL RH (for RHD) |
Connect the connector.
Attach the 5 clips, claw and 3 guides to install the instrument side panel.
| 10. INSTALL COWL SIDE TRIM BOARD LH (for LHD) |
Attach the clip and claw to install the cowl side trim board.
Install the clip.
| 11. INSTALL COWL SIDE TRIM BOARD RH (for RHD) |
- HINT:
- Use the same procedure described for the LH side.
| 12. INSTALL DOOR SCUFF PLATE ASSEMBLY LH (for LHD) |
Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.
| 13. INSTALL DOOR SCUFF PLATE ASSEMBLY RH (for RHD) |
- HINT:
- Use the same procedure described for the LH side.
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (LandCruiser RM000003YMF011X.html).
| 15. CHECK SRS WARNING LIGHT |
Check the SRS warning light (LandCruiser RM000000XFD0N3X.html).