Rear View Monitor System (For Radio And Display Type) Precaution

  1. IGNITION SWITCH EXPRESSION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

  1. POINTS TO NOTE WHEN SERVICING

  1. NOTES FOR REAR TELEVISION CAMERA ASSEMBLY

Rear View Monitor System (For Radio And Display Type) -- Precaution



1.IGNITION SWITCH EXPRESSION

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
Off
Off
Ignition Switch ON
ON
On (IG)
Ignition Switch ACC
ACC
On (ACC)
Engine Start
START
Start

2.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (LandCruiser RM000003YMD00TX.html).

3.POINTS TO NOTE WHEN SERVICING

  1. Pay attention to the following point when servicing.

    1. When the lens of the rear television camera assembly is dirty, wash the lens with water and wipe it off with a soft cloth to obtain clear images. For heavy dirt, use neutral detergent to clean the lens.


4.NOTES FOR REAR TELEVISION CAMERA ASSEMBLY

  1. Notes for the rear television camera assembly

    1. The rear view monitor system may not function properly if subjected to a severe blow by any hard object.

    2. Do not scrub the camera. Scrubbing may scratch the camera and affect the image. Prevent organic solvents, waxes, bond removing solvents or glass coating from adhere to the cover. If such material adheres to the cover, clean it off immediately and wash with water.

    3. Exposing the camera to a sudden temperature change may affect proper functioning of the camera.

    4. A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.

  2. Images are difficult to discern even in normal conditions if:

    1. Electrical devices that generate interference are used in the cabin.

    2. Noise may occur in the image if accessories that generate radio waves have been installed.

    3. The camera lens is frosted over (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).

    4. The camera lens is dirty with snow, mud, etc.

    5. A strong beam of light, such as a sunbeam or headlight, hits the camera.

    6. It is too dark around the camera (at night, etc.).

    7. The ambient temperature around the camera is either too high or too low.

    8. The vehicle is tilted at a steep angle.

    9. The rear television camera assembly lens is scratched.

    10. The rear television camera assembly lens has drops of water on it or the humidity is high.

    11. When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.