Trip Switch -- Removal |
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column) |
Disable the Autoaway/Return function by changing the customize parameter (LandCruiser RM000004KI4013X.html).
- NOTICE:
- Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.
- HINT:
- Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.
Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.
Turn the ignition switch off.
| 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD) |
 |
Put protective tape around the instrument cluster finish panel ornament.
Text in Illustration *1 Protective Tape
Using a moulding remover, detach the 3 clips and remove the instrument cluster finish panel ornament.
| 3. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD) |
 |
Detach the 4 clips.
Disconnect each connector and remove the instrument panel finish plate garnish.
| 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY |
 |
Detach the 4 clips.
Disconnect each connector and remove the instrument panel finish panel.
| 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
 |
Detach the 4 claws, 2 clips and 2 guides and remove the instrument cluster finish panel.
| 6. REMOVE TRIP SWITCH |
Detach the 2 claws and remove the trip switch.
 |