Heated Oxygen Sensor Installation
INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Heated Oxygen Sensor -- Installation |
| 1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
Temporarily install the sensor to the exhaust pipe by hand.
Using SST, tighten the sensor.
- SST
- 09224-00010
- Torque:
- without SST:
- 44 N*m{449 kgf*cm, 32 ft.*lbf}
- with SST:
- 40 N*m{408 kgf*cm, 30 ft.*lbf}
Text in Illustration*a
| Fulcrum Length
|
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (LandCruiser RM000003YMD00TX.html).
- Make sure SST and the wrench are connected in a straight line.
Connect the sensor connector.
| 2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
Temporarily install the sensor to the exhaust pipe by hand.
Using SST, tighten the sensor.
- SST
- 09224-00010
- Torque:
- without SST:
- 44 N*m{449 kgf*cm, 32 ft.*lbf}
- with SST:
- 40 N*m{408 kgf*cm, 30 ft.*lbf}
Text in Illustration*a
| Fulcrum Length
|
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (LandCruiser RM000003YMD00TX.html).
- Make sure SST and the wrench are connected in a straight line.
