Purge Valve Inspection

Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	23 to 26 Ω
1 - Body ground	Always	10 MΩ or higher
2 - Body ground	Always	10 MΩ or higher

HINT:

When measuring the coil resistance make sure that the surface temperature of the purge VSV is 20°C.

Check the operation of the purge VSV.

1. Check that air does not flow from port E to port F.
   

   Text in Illustration

   *1	Port E
   *2	Port F
   *a	Does not flow
   	Air pressure





2. Apply battery voltage to the connector and check the VSV operation.
   

   OK:

   Measurement Condition	Specified Condition
   Battery positive (+) → terminal 1 Battery negative (-) → terminal 2	Air flows from port E to port F

   Text in Illustration

   *1	Port E
   *2	Port F
   	Air pressure

   If the result is not as specified, replace the purge VSV.