Oil Pump Reassembly

Using SST and a hammer, tap in a new oil seal.

SST

09350-30020(09351-32140)

HINT:

Make sure the oil seal end is flush with the outer edge of the pump body.

Coat the lip of the oil seal with MP grease.

Place the oil pump body on the torque converter clutch.

Coat the driven gear with ATF.

Install the driven gear to the oil pump body.

Coat the drive gear with ATF.

Install the drive gear to the oil pump body.

Coat a new O-ring with ATF and install it to the oil pump body.

Align the bolt holes of the stator shaft with the bolt holes of the oil pump body and install the stator shaft to the oil pump body.

Install the 14 bolts.

Torque:

11 N*m{110 kgf*cm, 8 ft.*lbf}

Coat 3 new oil seal rings with ATF.

Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

HINT:

After installing the oil seal rings, check that they rotate smoothly.

NOTICE:

Do not excessively widen the rings.

Place the oil pump body on the torque converter clutch.

Check that the drive gear rotates smoothly.

Remove the oil pump assembly from the torque converter clutch.

Coat a new O-ring with ATF and install it to the oil pump assembly.