Power Tilt And Power Telescopic Steering Column System Actuator Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)
POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM - Actuator Power Source Circuit |
DESCRIPTION
This is the power source for the power tilt and power telescopic steering column system.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY) |
Disconnect the G116 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Condition
| Specified Condition
|
G116-2 (+B) - Body ground
| Always
| 11 to 14 V
|
Text in Illustration*a
| Rear view of wire harness connector
(to Multiplex Tilt and Telescopic ECU)
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 2.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
G116-11 (GND) - Body ground
| Always
| Below 1 Ω
|
Text in Illustration*a
| Rear view of wire harness connector
(to Multiplex Tilt and Telescopic ECU)
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
