Dtc C1436 Yaw Rate Sensor Malfunction


DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR)

CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION

DTC C1436 Yaw Rate Sensor Malfunction


DESCRIPTION

Refer to DTC C1419 and C1435 (LandCruiser RM0000035P408IX_01.html).

DTC Code
DTC Detection Condition
Trouble Area
C1436
Either condition is met:
  1. With the vehicle stationary, the yaw rate and acceleration sensor output value is not 0°/s.
  2. An abnormal comparison value.
Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (LandCruiser RM000001EA302PX_02.html).

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the yaw rate and acceleration sensor, perform calibration (LandCruiser RM00000452J00ZX.html).
  2. Check the yaw rate and acceleration sensor signal after replacement (LandCruiser RM00000452K011X.html).
HINT:
When DTC U0123, U0124 and/or U0126 is output together with DTC C1436, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (LandCruiser RM000000YUO0SYX.html).
1.READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR)

  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Yaw Rate Sensor
    		Yaw rate and acceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s
    		Vehicle stationary: 0°/s
    Right turn: -128 to 0°/s
    Left turn: 0 to 127°/s
    		-

  1. Check that the yaw rate and acceleration sensor output value is displayed on the intelligent tester.

    Result
    Result
    		Proceed to
    NG
    		Yaw rate and acceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning
    		A
    Yaw rate and acceleration sensor output value is not 0°/s when vehicle is stationary
    		B
    OK
    		C



B
REPLACE YAW RATE AND ACCELERATION SENSOR (LandCruiser RM000000SS507KX.html)

C
USE SIMULATION METHOD TO CHECK (LandCruiser RM000003YMJ00XX.html)
A


2.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION

  1. Turn the ignition switch off.

  1. Check that the yaw rate and acceleration sensor is installed properly (LandCruiser RM000000SS207WX.html).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.


NG
INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY (LandCruiser RM000000SS207WX.html)
OK

REPLACE YAW RATE AND ACCELERATION SENSOR (LandCruiser RM000000SS507KX.html)