Power Source Network. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Networking. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Can Communication System (W/ Vsc) -- Problem Symptoms Table |
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | See page |
| Open in CAN Main Wire | CAN Main Bus Line | HILUX_TGN26 RM000004PES007X.html |
| Short in CAN Bus Lines | CAN Bus Line | HILUX_TGN26 RM000004PET007X.html |
| Short to B+ in CAN Bus Line | CAN Bus Line | HILUX_TGN26 RM000004PEY008X.html |
| Short to GND in CAN Bus Line | CAN Bus Line | HILUX_TGN26 RM000004PEZ008X.html |
| Open in One Side of CAN Branch Line | CAN Branch Line | HILUX_TGN26 RM000004PF0007X.html |
- HINT:
- Refer to How to Proceed with Troubleshooting for the CAN V bus check procedure.
| Symptom | Suspected Area | See page |
| "Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester | Skid Control ECU Communication Stop Mode | HILUX_TGN26 RM000004PEQ007X.html |
| "Spiral cable (Steering Angle Sensor)" is not displayed on the intelligent tester | Steering Angle Sensor Communication Stop Mode | HILUX_TGN26 RM000004PEP007X.html |
| "Yaw Rate Sensor" is not displayed on the intelligent tester | Yaw Rate Sensor Communication Stop Mode | HILUX_TGN26 RM000004PER007X.html |
| "ECM (Engine)" is not displayed on the intelligent tester | ECM Communication Stop Mode | HILUX_TGN26 RM000004PEX006X.html |