Engine Hybrid System. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
1Kd-Ftv Lubrication. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Oil Pressure Switch -- Installation |
1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY |
Apply adhesive to 2 or 3 threads of the engine oil pressure switch.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
- NOTICE:
- Do not apply adhesive to the oil inlet port of the engine oil pressure switch.
Using a 24 mm deep socket wrench, install the engine oil pressure switch to the oil cooler cover.
- Torque:
- 15 N*m{153 kgf*cm, 11 ft.*lbf}
- NOTICE:
- Do not start the engine for at least 1 hour after the installation.
Connect the engine oil pressure switch connector.
2. ADD ENGINE OIL |
Add new engine oil.
- Standard Oil Grade:
Item Oil Grade Oil Viscosity (SAE) w/o Glow Plug Controller G-DLD1, API CF-4, CF or ACEA B1 - 5W-30
- 10W-30
- 15W-40
- 20W-50w/ Glow Plug Controller for i-ART API CF-4, CF or ACEA B1 - 5W-30
- 10W-30
- 15W-40
- 20W-50
(5W-30 is best choice for fuel economy and good starting in cold winter.)for DPF ACEA C2 - 0W-30
- 5W-30
- Standard Capacity:
Item Specified Condition Drain and refill without oil filter change 6.6 liters (7.0 US qts, 5.8 Imp. qts) Drain and refill with oil filter change 6.9 liters (7.3 US qts, 6.1 Imp. qts) Dry fill 7.4 liters (7.8 US qts, 6.5 Imp. qts)
Install the oil filler cap.
3. INSPECT FOR OIL LEAK |
Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill engine oil above the full level mark.
4. INSTALL NO. 2 ENGINE UNDER COVER |
- Torque:
- 28 N*m{286 kgf*cm, 21 ft.*lbf}