Front Power Seat Motor Assembly (For Slide) -- Removal |
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
| 1. REMOVE FRONT SEAT ASSEMBLY |
| 2. REMOVE RECLINING POWER SEAT SWITCH KNOB |
Apply protective tape around the front seat cushion shield.
 |
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1 Protective Tape
| 3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
 |
Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 4 claws and remove the slide and vertical power seat switch knob.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1 Protective Tape
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH WITH FRONT INNER NO. 1 SEAT CUSHION SHIELD LH |
Remove the 2 screws.
 |
Remove the 3 screws.
 |
Detach the claw and guide.
Remove the front seat cushion shield LH with the front inner No. 1 seat cushion shield LH.
| 5. REMOVE FRONT POWER SEAT SWITCH LH |
 |
Remove the 3 screws.
Disconnect the connector and remove the front power seat switch LH.
| 6. REMOVE FRONT SEAT INNER CUSHION SHIELD LH |
Remove the screw.
 |
Detach the claw and guide.
Pull the front seat inner cushion shield LH to detach the claw and remove the front seat inner cushion shield LH.
 |
| 7. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
Disconnect the connector and detach the 3 clamps.
 |
Roll up the front seat cushion cover LH.
 |
Remove the nut and front seat inner belt assembly.
| 8. REMOVE FRONT SEAT CUSHION COVER WITH PAD |
Remove the hog rings.
 |
Bend the 2 front seat cushion frame claws upward.
Detach the hooks and remove the front seat cushion cover with pad.
| 9. REMOVE POWER SEAT MOTOR ASSEMBLY (for Slide) |
Detach the 2 wire harness clamps.
 |
Detach the 4 clamps indicated by the arrows in the illustration and remove the seat cushion spring.
Remove the 4 bolts and seat cushion frame.
 |
Put matchmarks on the seat track rail and sliding unit of the seat frame.
 |
Disconnect the connector.
Connect the positive (+) battery terminal to terminal 1 of the power seat motor and the negative (-) battery terminal to terminal 2 and slide the seat to the foremost position.
Text in Illustration *a Component without harness connected
(Power Seat Motor Assembly)
 |
Detach the claw and disconnect the connector from the seat frame.
 |
Loosen the 2 nuts.
Connect the positive (+) battery terminal to terminal 2 of the power seat motor and the negative (-) battery terminal to terminal 1 and slide the seat to the rearmost position.
Text in Illustration *a Component without harness connected
(Power Seat Motor Assembly)
 |
Using a 5 mm socket hexagon wrench, remove the 2 bolts.
 |
Using a 4 mm socket hexagon wrench, remove the 4 bolts.
Remove the 2 nuts and power seat motor assembly (for Slide) together with the slide cable.
- NOTICE:
- Do not apply excessive force to the slide cable (do not bend the slide cable 60° or more).
Remove the slide cable.
 |