Meter / Gauge System Accessory Meter Does Not Illuminate
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - BATTERY AND BODY GROUND)
METER / GAUGE SYSTEM - Accessory Meter does not Illuminate |
DESCRIPTION
This circuit provides power to the accessory meter assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the G32 accessory meter assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Condition
| Specified Condition
|
G32-12 (IG) - Body ground
| Ignition switch ON
| 11 to 14 V
|
G32-13 (ACC) - Body ground
| Ignition switch ACC
| 11 to 14 V
|
G32-14 (+B) - Body ground
| Always
| 11 to 14 V
|
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
G32-1 (GND1) - Body ground
| Always
| Below 1 Ω
|
G32-10 (SGND) - Body ground
| Always
| Below 1 Ω
|
G32-12 (IG) - Body ground
| Always
| 10 kΩ or higher
|
G32-13 (ACC) - Body ground
| Always
| 10 kΩ or higher
|
G32-14 (+B) - Body ground
| Always
| 10 kΩ or higher
|
Text in Illustration*a
| Front view of wire harness connector
(to Accessory Meter Assembly)
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
