Rear Crankshaft Oil Seal Installation

Apply MP grease to the lip of a new rear crankshaft oil seal.

Using SST and a hammer, tap in the rear crankshaft oil seal until its surface is flush with the rear oil seal retainer edge.

SST

09223-78010

NOTICE:

1. Keep the lip free from foreign matter.
   
2. Do not tap the oil seal at an angle.
   

Using SST, hold the crankshaft.

SST

09213-54015(91651-60855)
09330-00021

Install the front spacer, drive plate and ring gear and rear spacer to the crankshaft.

Text in Illustration

*1	Front Spacer
*2	Drive Plate and Ring Gear
*3	Rear Spacer
	Automatic Transmission Side

HINT:

As the front spacer, drive plate and ring gear and rear spacer are not reversible, be sure to install them in the direction shown in the illustration.

Clean the bolts and bolt holes.

Apply adhesive to 2 or 3 threads at the ends of the new bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Uniformly install and tighten the 8 bolts in several steps in the sequence shown in the illustration.

Torque:

83 N*m{846 kgf*cm, 61 ft.*lbf}

NOTICE:

Do not start the engine for at least 1 hour after installation.