Power Window Control System (W/ Jam Protection Function) -- Initialization |
| RESET (INITIALIZE) THE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
- NOTICE:
- Resetting the power window regulator motor assembly (initializing the pulse sensor) is necessary if one of the following occurs: 1) the battery cable is disconnected; 2) the power window regulator master switch assembly, power window regulator or power window regulator motor assembly is replaced or removed/installed; or 3) the PWR H-fuse or DOOR fuse is replaced. If resetting is not performed, the power window regulator master switch assembly will not be able to operate the auto up/down function and jam protection function.
Turn the ignition switch to ON.
Open the power window halfway by pressing the power window regulator master switch assembly.
Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
Check that the auto up/down function operates normally.
If the auto up/down function operates normally, reset operations are completed. If abnormal, follow the 3 steps below.Disconnect the cable from the negative (-) battery terminal for 10 seconds.
Connect the cable to the negative (-) battery terminal.
Perform the first 4 steps again.
If the auto up/down function operates normally, reset operations have been completed at this time. If abnormal, follow the 4 steps below.Turn the ignition switch to ON.
Open the power window halfway by pressing the power window regulator master switch assembly.
Fully pull up on the switch until the power window is fully closed and continue to hold the switch for approximately 12 seconds after the power window is fully closed.
Check that the auto up/down function operates normally.