Front Door Belt Moulding Removal

Vehicle Exterior. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Exterior Panels Trim. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. PRECAUTION (w/ Power Window)

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Window)

  4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

  5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  6. REMOVE DOOR PULL HANDLE

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

  9. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

  10. REMOVE FRONT DOOR NO. 1 TRIM BRACKET

  11. REMOVE FRONT DOOR SERVICE HOLE COVER LH

  12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

  13. REMOVE FRONT DOOR OUTER GLASS WEATHERSTRIP ASSEMBLY LH

Front Door Belt Moulding -- Removal


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. PRECAUTION (w/ Power Window)
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (HILUX_TGN26 RM000004QR1006X.html).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR300CX.html).


3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (w/ Power Window)


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. Using a moulding remover, detach the 2 clips.

  1. Disconnect the 4 claws and remove the power window regulator master switch assembly with front door armrest base panel.

    Text in Illustration
    *A
    		for Double Cab
    *B
    		for Single Cab, for Extra Cab


4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. Insert a clip remover between the plate and trim board.

    HINT:
    Tape the clip remover tip before use.
    Text in Illustration
    *1
    		Protective Tape

  1. Turn the handle counterclockwise to remove the snap ring, front door window regulator handle and plate.



5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. Detach the 2 clips and remove the front door lower frame bracket garnish.

    Text in Illustration
    *A
    		w/o Front No. 2 Speaker
    *B
    		w/ Front No. 2 Speaker


6. REMOVE DOOR PULL HANDLE


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. Remove the screw and door pull handle.



7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. for Double Cab:

    1. Remove the clip and screw.

      Text in Illustration
      *1
      		Clip
      *2
      		Screw

    2. Detach the 8 clips and remove the front door trim board.



    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. for Single Cab, for Extra Cab:

    1. Remove the clip and screw.

      Text in Illustration
      *1
      		Clip
      *2
      		Screw

    2. Detach the 9 clips and remove the front door trim board.



8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. w/ Power Mirror Control System:
    Disconnect the mirror connector.

  1. Remove the 3 nuts.

  1. Push down the claw and remove the outer rear view mirror assembly LH.



9. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. Detach the claw and 2 guides as indicated by the arrows in the order shown in the illustration.



    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. Disconnect the front door inside locking cable and front door lock remote control cable and remove the front door inside handle.



10. REMOVE FRONT DOOR NO. 1 TRIM BRACKET


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. Remove the 2 screws and front door No. 1 trim bracket.



11. REMOVE FRONT DOOR SERVICE HOLE COVER LH


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. Pull out the front door inside locking cable, front door lock remote control cable and wire harness from the front door service hole cover, and then remove the front door service hole cover.

    HINT:
    Remove any remaining butyl tape from the front door panel.


12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

  1. w/ Power Window:

    1. Temporarily install the power window regulator master switch assembly with front door armrest base panel.

    2. Connect the cable to the negative (-) battery terminal.

    3. Move the front door glass sub-assembly so that the front door glass bolts can be seen.

    4. Disconnect the cable from the negative (-) battery terminal.

      NOTICE:
      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR300CX.html).

    5. Remove the power window regulator master switch assembly with front door armrest base panel.

  1. w/o Power Window:

    1. Temporarily install the door window regulator handle.

    2. Move the front door glass sub-assembly so that the front door glass bolts can be seen.

    3. Remove the door window regulator handle.



    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. Remove the 2 bolts.

    NOTICE:
    After the bolts are removed, do not allow the front door glass to fall.


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. Remove the front door glass as indicated by the arrows in the order shown in the illustration.

    NOTICE:
    Do not damage the front door glass.


13. REMOVE FRONT DOOR OUTER GLASS WEATHERSTRIP ASSEMBLY LH


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Exterior Panels Trim.Front Bumper.Front Door Belt Moulding Removal

  1. Put protective tape around the front door outer glass weatherstrip.

    Text in Illustration
    *A
    		for Double Cab
    *B
    		for Single Cab, for Extra Cab
    *1
    		Protective Tape

  1. Detach the 5 claws and remove the front door outer glass weatherstrip.