Fuel Lid Lock Control Cable Assembly (For Single Cab) Removal

for Manual Seat:

HINT:

Use the same procedure described for the LH side.

for Bench Seat Type:
(HILUX_TGN26 RM000000Z9000EX.html)

Detach the 4 claws, 4 guides and 5 clips and remove the upper back panel garnish.

Put protective tape around the front door scuff plate.

Using a moulding remover, detach the 4 clips and 8 claws and remove the front door scuff plate.

Remove the part of the front door opening trim attached to the cowl side trim board.

Remove the clip.

Detach the 2 clips and remove the cowl side trim board.

Remove the bolt and disconnect the front seat outer belt floor anchor.

Remove the part of the front door opening trim attached to the lower quarter trim panel.

Detach the claw, 3 clips and 2 guides and remove the lower quarter trim panel.

Partially remove the floor carpet.

HINT:

It is not necessary to fully remove the floor carpet. Partially remove it so that the lock control cable can be removed in a later step.

Put protective tape around the rear No. 1 wheel opening extension.

Remove the 5 screws.

Detach the 11 clips and remove the No. 1 rear wheel opening extension.

Remove the 11 clips from the vehicle body.

Partially remove the rear wheel house liner.

HINT:

It is not necessary to fully remove the liner. Partially remove it so that the lock control cable can be removed in a later step.

Remove the fuel lid lock open lever.

Remove the grommet from the vehicle body.

Detach the cable from the clamps shown in the illustration.

Turn the fuel filler opening lid lock retainer counterclockwise and remove the cable from the fuel filler opening lid lock retainer.

Turn the fuel filler opening lid lock retainer clockwise and remove the fuel filler opening lid lock retainer as shown in the illustration.