Front Brake (For 4Wd And Pre-Runner) -- Removal |
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. REMOVE FRONT WHEEL |
| 2. DRAIN BRAKE FLUID |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 3. REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING |
for 15 inch Front Disc Brake:
Remove the pin hold clip.
Text in Illustration *1 Disc Brake Pad Guide Pin *2 Pin Hold Clip *3 Front Disc Brake Anti-rattle Spring Hold down the anti-rattle spring and remove the 2 disc brake pad guide pins.
Remove the anti-rattle spring.
- CAUTION:
- Do not remove the 2 disc brake pad guide pins without holding down the anti-rattle spring. The anti-rattle spring will eject with a force capable of causing injury.
for 16 inch Front Disc Brake:
Remove the 2 pin hold clips and 2 disc brake pad guide pins.
Text in Illustration *1 Disc Brake Pad Guide Pin *2 Pin Hold Clip *3 Front Disc Brake Anti-rattle Spring Remove the anti-rattle spring.
- NOTICE:
- The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.
for 16 inch Front Disc Brake:
(for TDV Made)Remove the 2 pin hold clips and 2 disc brake pad guide pins.
Text in Illustration *1 Disc Brake Pad Guide Pin *2 Pin Hold Clip *3 Front Disc Brake Anti-rattle Spring Hold down the anti-rattle spring and remove the 2 disc brake pad guide pins.
Remove the anti-rattle spring.
- CAUTION:
- Do not remove the 2 disc brake pad guide pins without holding down the anti-rattle spring. The anti-rattle spring will eject with a force capable of causing injury.
| 4. REMOVE FRONT DISC BRAKE PAD |
Remove the 2 front disc brake pads from the disc brake cylinder.
| 5. REMOVE FRONT ANTI-SQUEAL SHIM KIT |
Remove the 2 No. 1 anti-squeal shims and 2 No. 2 anti-squeal shims from each pad.
| 6. DISCONNECT FRONT NO. 1 WHEEL CYLINDER TUBE LH |
Using a union nut wrench, disconnect the tube from the cylinder.
 |
| 7. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH |
Remove the 2 bolts and disc brake cylinder.
 |
| 8. REMOVE FRONT DISC |
Put matchmarks on the disc and axle hub.
Text in Illustration *1 Matchmark
 |
Remove the disc.