Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Brake Control Dynamic Control Systems. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Front Speed Sensor (For 4Wd And Pre-Runner) -- Installation |
- HINT:
- The procedure listed below is for the LH side.
- Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
| 1. INSTALL SKID CONTROL SENSOR CLAMP LH |
Install the skid control sensor clamp with the bolt.
Text in Illustration *a Stopper - - - Torque:
- 14 N*m{138 kgf*cm, 10 ft.*lbf}
- NOTICE:
- Install the clamp so that the rotation stopper touches the knuckle.
| 2. INSTALL SKID CONTROL SENSOR CLAMP RH |
Install the skid control sensor clamp with the bolt.
Text in Illustration *a Stopper - - - Torque:
- 14 N*m{138 kgf*cm, 10 ft.*lbf}
- NOTICE:
- Install the clamp so that the rotation stopper touches the knuckle.
| 3. INSTALL FRONT SPEED SENSOR LH |
Install the speed sensor with the bolt.
Text in Illustration *A w/ VSC *B w/o VSC - Torque:
- 8.5 N*m{87 kgf*cm, 75 in.*lbf}
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- When installing the sensor, do not twist the wire harness.
Install the harness clamp with the bolt.
- Torque:
- 32 N*m{326 kgf*cm, 24 ft.*lbf}
- NOTICE:
- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
Attach the 2 clamps.
Attach the clamp.
 |
Install the 2 harness clamps with the 2 bolts.
- Torque:
- 32 N*m{326 kgf*cm, 24 ft.*lbf}
- NOTICE:
- When installing the clamps, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
Attach the 2 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
 |
Connect the connector.
Text in Illustration *A for LH *B for RH - NOTICE:
- Do not attach the connector to the radiator fan shroud before connecting the connector.
- Securely connect the connector.
Attach the 2 clamps and the connector.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
| 4. INSTALL FRONT WHEEL |
Install the front wheel.
- Torque:
- 105 N*m{1071 kgf*cm, 77 ft.*lbf}
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR3003X.html).
| 6. CHECK SPEED SENSOR SIGNAL |
w/ ABS:
(HILUX_TGN26 RM000000XHT090X.html)
w/ VSC:
(HILUX_TGN26 RM000000XHT091X.html)