Automatic Transmission System (For 2Tr-Fe) Monitor Drive Pattern

Drivetrain. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
A343E Automatic Transmission Transaxle. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. TEST MONITOR DRIVE PATTERN FOR ECT

Automatic Transmission System (For 2Tr-Fe) -- Monitor Drive Pattern



TEST MONITOR DRIVE PATTERN FOR ECT
CAUTION:
Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.
HINT:
Performing this drive pattern is one method to simulate the malfunction detection conditions of the ECT.
The DTCs may not be detected through ordinary, everyday driving. Also, DTCs may not be detected through this drive pattern.

  1. Preparation for driving

    1. Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).

    2. Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.
      Malfunctions are not detected when the atmospheric temperature is below -10°C (14°F).

  2. Drive pattern

    1. Drive the vehicle through all the gears.
      Stop → 1st → 2nd → 3rd → 4th → 4th (lock-up ON).

    2. Repeat the above drive pattern 3 times or more.

      NOTICE:
      1. When using the intelligent tester, the monitor status can be checked in the Data List (HILUX_TGN26 RM000000W7E0STX.html).
      2. In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.A343E Automatic Transmission Transaxle.Automatic Transmission System (For 2Tr-Fe).Automatic Transmission System (For 2Tr-Fe) Monitor Drive Pattern

HINT:
*: Drive at such a speed in the uppermost gear so as to engage lock-up. The vehicle can be driven at a speed lower than the speed shown in the above diagram in lock-up.