INSTALL RADIO RECEIVER WITH BRACKET (for Radio Receiver Type without USB Audio System)
INSTALL RADIO RECEIVER WITH BRACKET (for Radio Receiver Type with USB Audio System)
INSTALL RADIO AND DISPLAY RECEIVER WITH BRACKET (for Radio and Display Type)
INSTALL NAVIGATION RECEIVER WITH BRACKET (for Navigation Receiver Type)
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ USB Audio System)
Radio Antenna Cord -- Installation |
| 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Engage the 5 clamps and install the No. 2 antenna cord sub-assembly.
for 3 Connector Type:
Connect the connector.
Install the bolt.
- Torque:
- 8.4 N*m{86 kgf*cm, 74 in.*lbf}
Engage the clamp.
Connect the connector.
| 2. INSTALL RADIO RECEIVER WITH BRACKET (for Radio Receiver Type without USB Audio System) |
Connect each connector.
Engage the 4 clips.
- CAUTION:
- When installing the radio receiver with bracket, check that the wire harness and No. 2 antenna cord sub-assembly are not caught between the radio receiver with bracket and the instrument panel reinforcement assembly. Failure to do so may cause a short circuit.
Install the radio receiver with bracket with the 4 bolts.
| 3. INSTALL RADIO RECEIVER WITH BRACKET (for Radio Receiver Type with USB Audio System) |
Connect each connector.
Install the radio receiver with bracket with the 4 bolts.
- CAUTION:
- When installing the radio receiver with bracket, check that the wire harness and No. 2 antenna cord sub-assembly are not caught between the radio receiver with bracket and the instrument panel reinforcement assembly. Failure to do so may cause a short circuit.
| 4. INSTALL RADIO AND DISPLAY RECEIVER WITH BRACKET (for Radio and Display Type) |
Connect each connector.
Install the radio and display receiver with bracket with the 4 bolts.
- CAUTION:
- When installing the radio and display receiver with bracket, check that the wire harness and No. 2 antenna cord sub-assembly are not caught between the radio and display receiver with bracket and the instrument panel reinforcement assembly. Failure to do so may cause a short circuit.
| 5. INSTALL NAVIGATION RECEIVER WITH BRACKET (for Navigation Receiver Type) |
Connect each connector.
Engage the 4 clips.
- CAUTION:
- When installing the navigation receiver with bracket, check that the wire harness and No. 2 antenna cord sub-assembly are not caught between the navigation receiver with bracket and the instrument panel reinforcement assembly. Failure to do so may cause a short circuit.
Install the navigation receiver with bracket with the 4 bolts.
| 6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ USB Audio System) |
Engage the 4 clips to install the center instrument cluster finish panel sub-assembly.
 |
| 7. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY |