Generator Installation

Install the wire harness clamp bracket with the bolt.

Torque:

8.4 N*m{86 kgf*cm, 74 in.*lbf}

Temporarily install the generator assembly with the 2 bolts.

Torque:

Bolt A:

43 N*m{438 kgf*cm, 32 ft.*lbf}

Bolt B:

19 N*m{190 kgf*cm, 14 ft.*lbf}

Install the connector and wire harness clamp.

Install the wire harness to terminal B with the nut and install the terminal cap.

Torque:

9.8 N*m{100 kgf*cm, 87 in.*lbf}

Install the belt.

Turn bolt C to adjust the tension of the V-ribbed belt.

Tighten bolts A and B.

Torque:

Bolt A:

19 N*m{190 kgf*cm, 14 ft.*lbf}

Bolt B:

43 N*m{438 kgf*cm, 32 ft.*lbf}

NOTICE:

Confirm that bolt D is not loosened.

Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-ribbed belt.

1. The belt is cracked.
   
2. The belt is worn out to the extent that the cords are exposed.
   
3. The belt has chunks missing from the ribs.
   

Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the groove on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.

Check the V belt deflection and tension.

Deflection:

Item	Specified Condition
New belt	7.0 to 8.2 mm (0.276 to 0.323 in.)
Used belt	7.6 to 10.0 mm (0.299 to 0.394 in.)

Tension:

Item	Specified Condition
New belt	700 to 800 N (71 to 82 kg, 157 to 180 lb)
Used belt	550 to 750 N (56 to 77 kg, 124 to 169 lb)

HINT:

1. When inspecting the V belt deflection, apply 98 N (10 kgf) tensile force to it.
   
2. After installing a new belt, run the engine for approximately 5 minutes and then readjust the tension to (new belt) specifications.
   
3. Check the V-ribbed belt deflection and tension at the specified point.
   
4. V-ribbed belt tension and deflection should be checked after 2 revolutions of the engine.
   
5. V-ribbed belt tension and deflection should be checked at TDC crank angle and cold condition.
   
6. When adjusting a belt, adjust its deflection and tension to the intermediate values of the specification.
   
7. When reinstalling a belt which has been used for over 5 minutes, adjust its deflection and tension to the used belt specification.
   
8. When using a belt tension gauge, confirm its accuracy by using a master gauge first.
   
9. If using a sonic tension meter:
   

Weight:

15 g/rib*m

Width:

6 ribs

Span:

188 mm (7.40 in.) (w/ air Conditioning)

282 mm (11.1 in.) (w/o air Conditioning)