Front Seat Outer Belt Assembly Installation

Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.

Torque:

41 N*m{420 kgf*cm, 30 ft.*lbf}

Install the front seat outer belt assembly with the 2 bolts.

Torque:

Bolt A:

5.0 N*m{51 kgf*cm, 44 in.*lbf}

Bolt B:

41 N*m{420 kgf*cm, 30 ft.*lbf}

for Front Passenger Side:

1. Engage the clamp.
   

Connect the connector and lock the locking button as shown in the illustration.

NOTICE:

Securely lock the locking button.

Connect the shoulder anchor of the front seat outer belt assembly with the nut.

Torque:

41 N*m{420 kgf*cm, 30 ft.*lbf}

Engage the clip.

Install the upper center pillar garnish LH with the 2 screws.

Engage the 2 claws and 2 clips, and install the lower center pillar garnish LH.

Install the floor end of the front seat outer belt assembly with the bolt.

Torque:

41 N*m{420 kgf*cm, 30 ft.*lbf}

Check if the ELR locks.

NOTICE:

The check should be performed with the outer belt assembly installed.

1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
   

Install the floor end of the front seat outer belt assembly with the front seat belt anchor base.

Torque:

41 N*m{420 kgf*cm, 30 ft.*lbf}

Engage the clamp.

Connect the connector.

Check if the ELR locks.

NOTICE:

The check should be performed with the outer belt assembly installed.

1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
   

Engage the 3 claws and install the lap belt outer anchor cover.

Engage the 2 guides.

Engage the 2 claws and install the lap belt outer anchor cover.

for TMC Made:

1. Align the alignment mark (pink) on the weatherstrip and the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
   

   NOTICE:

   After installation, check that the corners fit correctly.

for TMMC Made:

1. Align the alignment mark (red) on the weatherstrip and the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
   

   NOTICE:

   After installation, check that the corners fit correctly.

Align the alignment mark (yellow) on the weatherstrip and the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.

NOTICE:

After installation, check that the corners fit correctly.

Engage the 6 claws and install the rear door scuff plate LH.

Engage the 8 claws and install the front door scuff plate LH.