Occupant Classification System -- Diagnosis System |
CHECK DLC3 |
Check the DLC3 (COROLLA_ZRE142 RM000000UZ20CBX.html).
SYMPTOM SIMULATION |
- HINT:
- The most difficult case in troubleshooting is when no symptoms occur. In such cases, a thorough customer problem analysis must be carried out. Then the same or similar conditions and the environment in which the problem occurred in the customer's vehicle should be simulated. No matter how experienced or skilled a technician may be, if he/she proceeds to troubleshooting without confirming the problem symptoms, he/she will likely overlook something important and make a wrong guess at some points in the repair operation.
- This leads to a standstill in troubleshooting.
VIBRATION METHOD: When a malfunction seems to occur as a result of vibration.
- HINT:
- Perform this simulation method only during the primary check period of approximately 6 seconds after the ignition switch is turned to ON.
PARTS OR SENSORS
Apply slight vibration with a finger to the part or sensor suspected to be the cause of the problem, and check whether the malfunction occurs.- NOTICE:
- Applying strong vibration to relays may open the relays.
CONNECTORS
Slightly shake the connector vertically and horizontally.WIRE HARNESS
Slightly shake the wire harness vertically and horizontally.- HINT:
- The connector joint and fulcrum of the vibration are the major areas that should be checked thoroughly.
![]() |
FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR |
Initial check
Turn the ignition switch to ON.
The passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
Approximately 6 seconds after the ignition switch is turned to ON, the passenger airbag ON/OFF indicator will indicate ON or OFF depending on the conditions listed below.
Front Passenger Seat Condition Passenger Airbag ON/OFF Indicator SRS Warning Light ON indicator OFF indicator Vacant OFF OFF OFF Adult is seated. ON OFF OFF Child is seated. OFF ON OFF Child restraint system is set. OFF ON OFF Front passenger occupant classification failure OFF ON ON - HINT:
- The passenger airbag ON/OFF indicator is based on the timing chart below in order to check the indicator light circuit.
- When the occupant classification system has trouble, both the SRS warning light and the passenger airbag ON/OFF indicator ("OFF") come on. In this case, check the DTCs in the airbag system first.
CHECK PASSENGER AIRBAG ON/OFF INDICATOR |
Turn the ignition switch to ON.
Check that the passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 seconds, then goes off for approximately 2 seconds.
- HINT:
- Refer to the table in the previous step regarding the passenger airbag ON/OFF indicator when the ignition switch is turned to ON and approximately 6 seconds pass.
![]() |