Seat Position Sensor Installation

Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.

Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor with seat slide position sensor protector.

NOTICE:

1. If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
   
2. When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   

HINT:

Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor with seat slide position sensor protector.

Torque:

8.0 N*m{82 kgf*cm, 71 in.*lbf}

Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

Connect the connector.

Check that there are no loose parts after installing the seat position sensor.

Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.

Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor with seat slide position sensor protector.

NOTICE:

1. If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
   
2. When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   

HINT:

Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor with seat slide position sensor protector.

Torque:

8.0 N*m{82 kgf*cm, 71 in.*lbf}

Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

Connect the connector.

Check that there are no loose parts after installing the seat position sensor.

Engage the 2 guides.

Engage the claw.

Install the front seat cushion shield with the 3 screws.

Install the vertical adjusting handle with the 2 screws.

Engage the 2 claws and install the vertical adjuster knob cap.

Engage the claw and install the reclining adjuster release handle.

Install the front seat assembly (COROLLA_ZRE142 RM000000Z8T0D2X.html).

Install the front seat assembly (COROLLA_ZRE142 RM000000Z8T0D1X.html).