Black Out Tape (For Rear Door) Removal

Using a clip remover, remove the snap ring.

Remove the rear door window regulator handle assembly and rear door regulator inside handle plate.

Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel.

Using a moulding remover, disengage the 2 clips and 7 claws, and remove the rear door armrest upper base panel.

Using a moulding remover, disengage the 2 clips and 7 claws.

Disconnect the connector and remove the rear door armrest upper base panel.

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and disconnect the door armrest cap.

Remove the 2 screws.

Using a clip remover, disengage the 8 clips.

Disengage the 4 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.

Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

Disconnect the rear door lock remote control cable and rear door inside locking cable, and remove the rear door inside handle sub-assembly.

Remove the rear door inner glass weatherstrip from the rear door panel.

Remove the 2 screws and the rear door trim bracket.

w/ Power door lock:

1. Disconnect the connector.
   

Remove the rear door service hole cover.

HINT:

Remove any remaining butyl tape from the door.

Remove the rear door glass run.

Remove the 2 bolts, screw, and the rear door window division bar sub-assembly.

Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.

Remove the rear door quarter window glass from the rear door quarter window weatherstrip.

Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

NOTICE:

Do not damage the door glass.

Put protective tape around the front door belt moulding assembly.

Using a screwdriver with its tip taped, disengage the 6 claws from the inside of the rear door.

Using a moulding remover, disengage the 2 clips and remove the rear door belt moulding assembly.

Remove the upper part of the rear door weatherstrip to the extent that allows removal of the black out tape.

Using a heat light, heat the No. 2 black out tape.

Heating Temperature:

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)

NOTICE:

Do not heat the vehicle body excessively.

Pull back an edge of the No. 2 black out tape and pull it parallel to the vehicle body to pull it off.

Using a heat light, heat the No. 4 black out tape.

Heating Temperature:

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)

NOTICE:

Do not heat the vehicle body excessively.

Pull back an edge of the No. 4 black out tape and pull it parallel to the vehicle body to pull it off.

Using a heat light, heat the No. 2 black out tape.

Heating Temperature:

Item	Temperature
Vehicle Body	40 to 60°C (104 to 140°F)

NOTICE:

Do not heat the vehicle body excessively.

Pull back an edge of the No. 2 black out tape and pull it parallel to the vehicle body to pull it off.