Front Crankshaft Oil Seal Removal

Hold the rear of the cover and raise it to disengage the 2 clips on the rear of the cover. Continue to raise the cover to disengage the 2 clips on the front of the cover to remove the cover.

NOTICE:

Attempting to disengage both front and rear clips at the same time may cause the cover to break.

Loosen bolts A and B.

Loosen bolt C, then remove the V-ribbed belt.

NOTICE:

Do not loosen bolt D.

Using SST, hold the pulley in place and loosen the pulley bolt.

SST

09213-58014(91551-80840)
09330-00021

NOTICE:

Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing chain cover sub-assembly.

Using SST, remove the crankshaft pulley and pulley bolt.

SST

09950-50013(09951-05010,09952-05010,09953-05020,09954-05021)

Using a knife, cut off the lip of the oil seal.

Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.