Lighting System Parking Brake Switch Circuit

Vehicle Exterior. Corolla. Zre142 Aze141
Lighting (Ext). Corolla. Zre142 Aze141

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (DAYTIME RUNNING LIGHT RELAY - BODY GROUND)

INSPECT PARKING BRAKE SWITCH ASSEMBLY

LIGHTING SYSTEM - Parking Brake Switch Circuit


DESCRIPTION

The daytime running light relay receives the parking brake switch signal.

WIRING DIAGRAM


Corolla. Zre142 Aze141.Lighting (Ext).Lighting System.Lighting System Parking Brake Switch Circuit


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DAYTIME RUNNING LIGHT RELAY - BODY GROUND)

  1. Disconnect the E91 daytime running light relay connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    		Condition
    		Specified condition
    E91-9 (PKB) - Body ground
    		Parking brake is released
    		10 kΩ or higher
    E91-9 (PKB) - Body ground
    		Parking brake is applied
    		Below 1 Ω


NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (COROLLA_ZRE142 RM000002CE20DLX.html)

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    Corolla. Zre142 Aze141.Lighting (Ext).Lighting System.Lighting System Parking Brake Switch Circuit

  1. Remove the parking brake switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    		Condition
    		Specified resistance
    1 - Switch body
    		OFF
    (When shaft is pressed)
    		10 kΩ or higher
    1 - Switch body
    		ON
    (When shaft is not pressed)
    		Below 1 Ω


NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (COROLLA_ZRE142 RM000003D7400NX.html)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (PARKING BRAKE SWITCH CIRCUIT)