Dtc B2287 Lin Communication Master Malfunction

Communication System. Camry. Acv40 Gsv40
Multiplex Communication. Camry. Acv40 Gsv40

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK DTC OUTPUT

CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - MAIN BODY ECU)

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

CHECK DTC OUTPUT

DTC B2287 LIN Communication Master Malfunction


DESCRIPTION

This DTC is stored when there is an open, short or ECU communication malfunction between the main body ECU (instrument panel junction block) and certification ECU (smart key ECU assembly).

DTC Code
DTC Detection Condition
Trouble Area
B2287
There is an open, short or ECU communication malfunction between the main body ECU (instrument panel junction block) and certification ECU (smart key ECU assembly).
  1. Main body ECU (Instrument panel junction block)
  2. Certification ECU (Smart key ECU assembly)
  3. Wire harness or connector

WIRING DIAGRAM


Camry. Acv40 Gsv40.Multiplex Communication.Lin Communication System. Dtc B2287 Lin Communication Master Malfunction


INSPECTION PROCEDURE

NOTICE:
  1. If the certification ECU (smart key ECU assembly) is replaced, register the key.
  2. When using the intelligent tester to troubleshoot with the engine switch off:
    Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.
1.CHECK DTC OUTPUT

  1. Clear the DTC (CAMRY_ACV40 RM000002XHS00KX.html).

  1. Recheck for DTCs.

    HINT:
    Check the both Entry & Start and Main Body DTCs.
    Result:
    Result
    		Proceed to
    Only DTC B2287 is output.
    		A
    DTC B2287 and B2785 are output simultaneously.
    		B
    HINT:
    When DTC B2287 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.


B
GO TO DTC B2785 (CAMRY_ACV40 RM000002XHV047X.html)
A


2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - MAIN BODY ECU)

  1. Disconnect the IR junction block connector.



    Camry. Acv40 Gsv40.Multiplex Communication.Lin Communication System. Dtc B2287 Lin Communication Master Malfunction

  1. Disconnect the E74 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    E74-10 (LIN) - IR-9 (LIN1)
    		Always
    		Below 1 Ω
    E74-10 (LIN) - Body ground
    		Always
    		10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

  1. Replace the main body ECU (instrument panel junction block).


NEXT


4.CHECK DTC OUTPUT

  1. Clear the DTC (CAMRY_ACV40 RM000002XHS00KX.html).

  1. Recheck for DTCs.

    OK:
    DTC B2287 is not output.


NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (MAIN BODY ECU WAS DEFECTIVE)