Unlock Warning Switch Installation

Engage the 2 claws to install the unlock warning switch assembly to the steering lock sub-assembly.

Make sure that the ignition switch lock cylinder assembly is in the ACC position.

Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.

Make sure that the ignition switch lock cylinder assembly is securely installed.

Temporarily install the assembled steering lock and its bracket to the steering column assembly using 2 new tapered-head bolts.

Tighten the 2 tapered-head bolts until the bolt heads break off.

Align the transponder key amplifier with the upper bracket. Tilt the amplifier slightly and slide it into position.

Push the transponder key amplifier to install it to the upper bracket.

NOTICE:

Do not push the amplifier with excessive force.

Install the steering column assembly with the bolt and 2 nuts.

Torque:

21 N*m{214 kgf*cm, 16 ft.*lbf}

Connect the connectors and wire harness clamps to the steering column assembly.

Align the matchmarks on the steering intermediate shaft assembly and the power steering link assembly.

Install the bolt.

Torque:

35 N*m{360 kgf*cm, 26 ft.*lbf}

Install the clamp to the steering column hole shield.

Engage the 2 claws to install the No. 1 air duct.

Install the turn signal switch assembly with spiral cable sub-assembly to the steering column assembly with the clamp.

Connect the connectors to the turn signal switch assembly with spiral cable sub-assembly.

Engage the claw to install the upper steering column cover.

Engage the 2 claws to install the lower steering column cover.

Install the 2 screws.

Check that the ignition switch is off.

Check that the battery negative (-) cable is disconnected.

CAUTION:

Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

NOTICE:

Do not turn the spiral cable by the airbag wire harness.

Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable by the airbag wire harness.

HINT:

The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

Align the matchmarks on the steering wheel assembly and steering main shaft.

Install the steering wheel assembly set nut.

Torque:

50 N*m{510 kgf*cm, 37 ft.*lbf}

Connect the connectors to the spiral cable sub-assembly.

Check that the ignition switch is off.

Check that the battery negative (-) terminal is disconnected.

CAUTION:

Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

Support the steering pad with one hand.

Connect the 2 airbag connectors to the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.

Connect the horn connector to the steering pad.

Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

Using a "TORX" socket (T30), tighten the 2 "TORX" screws.

Torque:

8.8 N*m{90 kgf*cm, 78 in.*lbf}

Install the air hose and connect the connector.

Engage the 2 claws and the DLC3.

Engage the claw and the 4 clips.

Instal the lower instrument panel finish panel LH with the screw <B> and bolt <A>.

Engage the 2 clips.

Install the cowl side trim sub-assembly LH with the cowl side trim clip.

Engage the 7 claws and 3 clips, then install the front door scuff plate LH.