Front Washer Motor Removal

Remove the 7 clips and cool air intake duct seal.

Put protective tape around the front bumper assembly.

Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.

Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.

Disconnect each connector.

w/ TOYOTA Parking Assist-sensor System:

1. Disengage the clamp and disconnect the No. 1 ultrasonic sensor connector.
   

w/ Headlight Cleaner System:

1. Disconnect the headlight cleaner washer hose.
   

Remove the front bumper assembly.

Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

Disconnect the connector.

Remove the windshield washer motor and pump assembly.

Disconnect the connector.

Remove the headlight cleaner motor and pump assembly.