Engine Front Oil Seal Installation

Apply MP grease to a new oil seal lip.

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

SST

09316-60011(09316-00011)

NOTICE:

1. Keep the lip free of foreign matter.
   
2. Do not tap the oil seal at an angle.
   

Align the pulley set key with the key groove of the pulley, and slide on the pulley.

Using SST, install the pulley bolt.

SST

09213-70011(09213-70020)
09330-00021

Torque:

250 N*m{2,550 kgf*cm, 184 ft.*lbf}

Install the V-ribbed belt.

Using SST, turn the belt tensioner counterclockwise and remove the bar.

SST

09249-63010

If it is difficult to install the V-ribbed belt, perform the following procedure:

1. Put the V-ribbed belt on every pulley except the tensioner pulley as shown in the illustration.
   

2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
   

   NOTICE:

   1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      
   2. Check that the V-ribbed belt is properly set to each pulley.
      

3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.
   

Engage the 3 retainers to install the V-bank cover.