Headlight Dimmer Switch -- Removal |
1. PRECAUTION |
w/ Navigation System:
- NOTICE:
- After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
4. REMOVE NO. 2 LOWER STEERING WHEEL COVER |
Using a screwdriver, disengage the claw and remove the No. 2 lower steering wheel cover.
- HINT:
- Tape up the screwdriver tip before use.
![]() |
5. REMOVE NO. 3 LOWER STEERING WHEEL COVER |
Using a screwdriver, disengage the claw and remove the No. 3 lower steering wheel cover.
- HINT:
- Tape up the screwdriver tip before use.
![]() |
6. REMOVE STEERING PAD |
Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
![]() |
Disconnect the horn connector from the steering pad.
Disconnect the 2 airbag connectors and remove the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the steering pad.
7. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the steering main shaft.
Disconnect the connectors from the spiral cable.
Using SST, remove the steering wheel assembly.
- SST
- 09950-50013(09951-05010,09952-05010,09953-05020,09954-05031)
![]() |
8. REMOVE STEERING COLUMN COVER |
Remove the 2 screws <D>.
![]() |
Disengage the 2 claws and remove the lower steering column cover.
Disengage the claw and remove the upper steering column cover.
9. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR |
Disconnect the connectors from the spiral cable with steering angle sensor.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
![]() |
Disengage the 3 claws and remove the spiral cable with steering angle sensor.
10. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY |
Disconnect the 2 connectors.
![]() |
Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
- NOTICE:
- If the claw is pushed with excessive force, it may break.
11. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY |
Disconnect the connector.
![]() |
Disengage the clamp as shown in the illustration.
Disengage the claw and remove the headlight dimmer switch assembly as shown in the illustration.
![]() |