Front Seat Inner Belt Assembly -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Manual Seat) |
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (CAMRY_ACV40 RM000000KT10BKX.html).
- NOTICE:
- After the ignition switch is turned off, the navigation receiver assembly (HDD navigation system) records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
| 2. REMOVE FRONT SEAT HEADREST ASSEMBLY |
| 3. REMOVE SEAT TRACK COVER (for Manual Seat) |
Move the front seat assembly fully forward by operating the slide handle.
Using a screwdriver, disengage the 4 claws and remove the seat track cover.
- HINT:
- Tape the screwdriver tip before use.
 |
| 4. REMOVE INNER SEAT TRACK BRACKET COVER (for Manual Seat) |
Using a screwdriver, disengage the 4 claws and remove the inner seat track bracket cover.
- HINT:
- Tape the screwdriver tip before use.
 |
| 5. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) |
Move the front seat assembly to the rearmost position by operating the slide handle.
Remove the 2 bolts on the front seat track bracket.
 |
Move the front seat assembly fully forward by operating the slide handle.
Remove the 2 bolts on the rear seat track bracket.
 |
Move the front seat assembly to the center position and adjust the seatback to the vertical position by operating the slide and reclining adjuster release handle.
Disconnect the connectors and clamp.
Remove the front seat assembly.
| 6. REMOVE SEAT TRACK COVER (for Power Seat) |
Operate the power seat switch knob and move the seat to the position farthest forward.
Using a screwdriver, detach the 4 claws and remove the seat track cover.
- HINT:
- Tape the screwdriver tip before use.
|
| 7. REMOVE INNER SEAT TRACK BRACKET COVER (for Power Seat) |
Using a screwdriver, detach the 4 claws and remove the inner seat track bracket cover.
|
| 8. REMOVE FRONT SEAT ASSEMBLY (for Power Seat) |
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front seat track bracket.
 |
Operate the power seat switch knob and move the seat to the position farthest forward.
Remove the 2 bolts on the rear seat track bracket.
|
Disconnect the cable from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (CAMRY_ACV40 RM000000KT10BKX.html).
Disconnect the connectors under the seat. Then remove the front seat assembly.
| 9. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat) |
for Driver seat:
Disconnect the connectors and disengage the 4 clamps.
 |
for Passenger seat:
Disconnect the connector and disengage the 3 clamps.
Remove the nut and front seat inner belt assembly.
 |
| 10. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) |
for Driver seat:
Disconnect the connectors and disengage the 4 clamps.
 |
for Passenger seat:
Disconnect the connector and disengage the 3 clamps.
Remove the nut and front seat inner belt assembly.
|