Rear Axle Hub And Bearing Installation

Install the hub and bearing assembly with the 4 bolts.

Torque:

80 N*m{816 kgf*cm, 59 ft.*lbf}

Connect the skid control sensor connector.

NOTICE:

Do not twist the sensor wire when connecting it.

Using a dial indicator, check for looseness near the center of the axle hub.

Maximum:

0.05 mm (0.0020 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

Maximum:

0.07 mm (0.0027 in.)

NOTICE:

Ensure that the dial indicator is set perpendicular to the measurement surface.

Aligning the matchmarks, install the rear disc.

HINT:

When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.

Install the rear disc brake caliper with the 2 bolts.

Torque:

62 N*m{630 kgf*cm, 46 ft.*lbf}

NOTICE:

Do not twist the brake hose when installing the rear disc brake caliper assembly LH.

Install the rear flexible hose with the bolt.

Torque:

19 N*m{192 kgf*cm, 14 ft.*lbf}

ABS: CAMRY_ACV40 RM000001JBD011X.html

VSC: CAMRY_ACV40 RM000000XHT028X.html