Can Communication System (For Lhd) Combination Meter Ecu Communication Stop Mode

Communication System. Camry. Acv40 Gsv40
Can Communication. Camry. Acv40 Gsv40

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK CAN BUS LINE FOR DISCONNECTION (COMBINATION METER MAIN BUS WIRE)

CHECK HARNESS AND CONNECTOR (ES, IG+, B2)

CAN COMMUNICATION SYSTEM (for LHD) - Combination Meter ECU Communication Stop Mode


DESCRIPTION


Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
  1. "Combination Meter" not displayed on "Communication Bus Check" screen of intelligent tester
  2. Applies to "Combination Meter ECU Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of the combination meter ECU
  2. Combination meter main wire or connector
  3. Combination meter

WIRING DIAGRAM


Camry. Acv40 Gsv40.Can Communication.Can Communication System (For Lhd).Can Communication System (For Lhd) Combination Meter Ecu Communication Stop Mode


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
HINT:
Operating the ignition switch, any other switches or any triggers related ECU and sensor communication on the CAN, which would cause resistance reading variations.
1.CHECK CAN BUS LINE FOR DISCONNECTION (COMBINATION METER MAIN BUS WIRE)


    Camry. Acv40 Gsv40.Can Communication.Can Communication System (For Lhd).Can Communication System (For Lhd) Combination Meter Ecu Communication Stop Mode

  1. Turn the ignition switch off.

  1. Disconnect the combination meter ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    F1-17 (CANH) - F1-18 (CANL)
    		Ignition switch off
    		108 to 132 Ω


NG
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (COMBINATION METER MAIN BUS LINE)
OK


2.CHECK HARNESS AND CONNECTOR (ES, IG+, B2)


    Camry. Acv40 Gsv40.Can Communication.Can Communication System (For Lhd).Can Communication System (For Lhd) Combination Meter Ecu Communication Stop Mode

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    F1-24 (ES) - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    F1-13 (IG+) - Body ground
    		Ignition switch on
    		10 to 14 V
    F1-2 (B2) - Body ground
    		Always
    		10 to 14 V


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY