Transmission Control Cable Assembly Adjustment

When shifting from the P to the R position with the ignition switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

Move the shift lever to the N position.

Remove the nut and transmission control cable from the control shaft lever.

Align the protrusions of the park/neutral position switch.

Move the slider in the directions indicated by the arrows and pull up the lock piece.

NOTICE:

Do not damage the boot.

Install the control cable to the control shaft with the nut.

Torque:

13 N*m{130 kgf*cm, 9 ft.*lbf}

NOTICE:

1. If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
   
2. When tightening the nut, confirm that the control cable is properly stretched.
   

Push in the lock piece.

NOTICE:

Firmly push in the lock piece until the slider lock is engaged.

Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.