Engine Rear Oil Seal Installation

Apply MP grease to a new oil seal lip.

NOTICE:

Keep the lip free from foreign matter.

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST

09223-15030
09950-70010(09951-07100)

NOTICE:

Wipe off extra grease from the crankshaft.

Using SST, hold the crankshaft.

SST

09213-54015(91651-60855)
09330-00021

Clean the bolt and the bolt hole.

Apply adhesive to 2 or 3 threads of the bolt end.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

Install the flywheel with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.

Torque:

130 N*m{1,330 kgf*cm, 96 ft.*lbf}

Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.

SST

09301-00220

NOTICE:

Take care not to insert the clutch disc assembly in the wrong direction.

Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.

Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin on the top.

Torque:

19 N*m{195 kgf*cm, 14 ft.*lbf}

HINT:

1. Following the order in the illustration, evenly tighten the bolts one turn at a time.
   
2. Lightly move SST up and down, and right and left after checking that the disc is in the center to tighten the bolts.
   

SST

09301-00210

Using SST, hold the crankshaft.

SST

09213-54015(91651-60855)
09330-00021

Clean the bolt and the bolt hole.

Apply adhesive to 2 or 3 threads of the bolt end.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

Install the front spacer, drive plate and rear spacer with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.

Torque:

98 N*m{1,000 kgf*cm, 72 ft.*lbf}