Brake. Camry. Acv40 Gsv40
Brake Control. Camry. Acv40 Gsv40
CHECK CAN COMMUNICATION SYSTEM
CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
INSPECT COMBINATION METER ASSEMBLY
VEHICLE STABILITY CONTROL SYSTEM - Slip Indicator Light Remains ON |
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.If the skid control ECU stores a DTC, the SLIP indicator light will come on in the combination meter.
The SLIP indicator light blinks during VSC and/or TRC operation.
When the system fails, the SLIP indicator light comes on to warn the driver (CAMRY_ACV40 RM000000XHP08UX.html).
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (CAMRY_ACV40 RM000000XHR05BX.html).
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (CAMRY_ACV40 RM000000WIB09JX.html for LHD, or CAMRY_ACV40 RM000000WIB09KX.html for RHD).
- Result:
Condition Proceed to DTC is not output A DTC is output B
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
- OK:
- The connector should be securely connected.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
- Standard voltage:
- 11 to 14 V
|
| ||||
| OK | |
| 4.INSPECT COMBINATION METER ASSEMBLY |
Perform Active Test of the combination meter (meter CPU) using the intelligent tester (CAMRY_ACV40 RM0000012G700LX.html).
- OK:
- The SLIP indicator light turns on or off in accordance with the intelligent tester.
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (CAMRY_ACV40 RM000000XHN08DX.html).
|
| ||||
| OK | ||
| ||