Vehicle Stability Control System Vsc Warning Light Does Not Come On

Brake. Camry. Acv40 Gsv40
Brake Control. Camry. Acv40 Gsv40

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK CAN COMMUNICATION SYSTEM

CHECK VSC WARNING LIGHT

INSPECT COMBINATION METER ASSEMBLY

VEHICLE STABILITY CONTROL SYSTEM - VSC Warning Light does not Come ON


DESCRIPTION

The skid control ECU communicates with the combination meter via CAN communication. If the ECU stores a DTC, the DTC will be displayed on the multi information display in the combination meter.

WIRING DIAGRAM


Camry. Acv40 Gsv40.Brake Control.Anti-Lock Brake System.Vehicle Stability Control System Vsc Warning Light Does Not Come On


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (CAMRY_ACV40 RM000000XHR024X.html).
1.CHECK CAN COMMUNICATION SYSTEM

  1. Check if the CAN communication system DTC is output (CAMRY_ACV40 RM000000WIB03ZX.html for LHD, or CAMRY_ACV40 RM000000WIB040X.html for RHD).

    Result:

    Condition
    		Proceed to
    DTC is not output
    		A
    DTC is output
    		B


B
INSPECT CAN COMMUNICATION SYSTEM
A


2.CHECK VSC WARNING LIGHT

  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select "VSC Warning Lamp" in the Active Test and operate the multi information display using the intelligent tester.

    ABS / VSC / TRC:
    Item (Display)
    		Vehicle Condition / Test Details
    		Diagnostic Note
    VSC Warning Lamp
    		Turn multi information display ON / OFF
    		Observe combination meter

  1. Check that "ON" and "OFF" of the multi information display are indicated on the combination meter when using the intelligent tester.

    OK:
    The multi information display turns on or off in accordance with the intelligent tester.
    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (CAMRY_ACV40 RM000000XHN02MX.html).


OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


3.INSPECT COMBINATION METER ASSEMBLY

  1. Turn the ignition switch off.

  1. Perform Active Test of the combination meter (meter CPU) using the intelligent tester (CAMRY_ACV40 RM0000012G700LX.html).

    OK:
    The multi information display turns on or off in accordance with the intelligent tester.
    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (CAMRY_ACV40 RM000000XHN02MX.html).


NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY